smart ebike EB 001 Manual De Instrucciones página 22

Supplement to Original Owner's Manual
20
X
Place the rubber cap over the electrical
contacts in the battery holder.
X
Before transporting the ebike on a
vehicle's rear rack or roof carrier,
remove any accessories that are not per-
manently attached to the ebike, e.g.
control console, smartphone and mesh
pockets.
i
It is not permitted to carry the smart
ebike battery on board a passenger aero-
plane.
Cleaning and care
G
WARNING
The water jet from a high-pressure cleaner
can cause damage to the tyres or drive belt
that is not visible on the surface. Compo-
nents damaged in this way can fail unex-
pectedly. There is a risk of an accident.
Do not use a high-pressure cleaner when
cleaning the ebike. Have damaged tyres or
drive belt replaced without delay.
G
WARNING
Braking efficiency is reduced after
washing the bike. There is a risk of an
accident.
After washing, brake the ebike carefully,
paying attention to traffic conditions,
until full braking efficiency is restored.
! Do not use a high-pressure cleaner when
cleaning the smart ebike. The powerful
water jet could enter the bearings or
damage the electrical components of the
drive system.
Do not point the water jet from a hose
directly at the electrical components or
the mountings of wheels, pedal cranks
and head bearings.
X
Do not use abrasive products, polish or
bleach.
X
Do not use solvents or cleaning agents
containing solvents.
X
Place the rubber cap over the electrical
contacts in the battery holder.
X
Use as little water as possible and keep
water away from electrical contacts.
Lukewarm water (approx. 20 †) is com-
pletely sufficient for cleaning.
X
Remove heavy soiling using mild, com-
mercially available cleaning agents or
special biological bicycle cleaners.
X
Do not allow these cleaning agents to act
for too long or to dry out.
X
Do not use concentrated cleaning agents.
X
Clean the ebike using a soft cloth, sponge
or industrial cotton wadding. Do not use
abrasive cloths.
X
After cleaning, dry the ebike using soft
paper or a cotton cloth.
X
Clean the battery holder using a damp
cloth.
X
After cleaning, check the electrical con-
nectors and let them dry before riding
the ebike.
Maintenance
Regular work
smart recommends that you have the ebike
serviced once a year at a qualified spe-
cialist workshop.
Additionally before each journey
Check the lighting system
Every 300 - 500 km
Check that the pedal assist is functi-
R
oning properly; see the "Pedal-assist
technology" section in the original
Owner's Manual for the ebike.
Check that the sensor in the front wheel
R
brake is functioning properly; see the
"Braking with disc brakes" section in
the original Owner's Manual for the
ebike.