Kerbl 37116 Instrucciones De Uso página 6

Hand Power Puller – Cable pull
EN
1. Safety instructions
1.1. Generell safety instructions
It is only possible to work safely with this tool by reading the corresponding operating and safety instructions in their
entirety and following them to the letter.
Application
The warranty issued by the manufacturer and any liability claims against the manufacturer shall be rendered null
and void if the device is used in a manner not in accordance with its designated use or if alterations are made to it.
Check all components before use
Have any damaged parts repaired by a specialist or the manufacturer. Incorrectly performed repairs represent a risk
of accidents to the user. Always use original spare parts for any repairs.
Restrict unauthorised access
Make sure that no-one, in particular children, can get near the tool without your permission.
Never leave your tool in use unattended
Never leave your tool in use unattended, as unauthorized persons may attempt to operate it,
thereby creating an unsafe condition.
Keep your workplace tidy
An untidy workplace increases the danger of accident.
Take the ambient conditions into account
Protect your device against all liquids and moisture. Otherwise there is the risk of mechanics and rope being
affected by rust.
Look after your tool
Always keep your product in a safe, dry place out of the reach of children. Pay attention to any maintenance
requirements. Check your device at regular intervals. Always use original accessories and spare parts.
National and international regulations
Comply with national and international regulations governing health and safety at work.
1.2 Device-Dependent Safety Instructions
Caution: Make sure your Hand Power Puller is maintened in safe and proper working condition by observing the
following rules:
1. Inspect cable regularly to examine the frays, kinks, broken strands or distortion.
2. Do not pull cable over or around a corner.
3. Do not wrap cable around any object and hook it back on itself.
4. Do not overload; Know how much load is allowed when you are pulling.
5. Do not use a "cheater" pipe or other device to lengthen the handle for additional leverage.
This will destroy the puller itself.
6. Do not operate puller with less than 3 wraps of cable on the spindle.
7. Please do use an adequate sling, eyebolt or other accessory attached to the load to be pulled.
And make sure that there is positive engagement of the puller hook to the load.
8. NOT FOR LIFTING!
6