Radio Operation - Sunbeam 89019 Instrucciones De Operación

1. On/Off/Auto
2. Sleep
3. Snooze Button
4. Clock/Set Time/Set Alarm switch
5. Minute set button
6. Hour set button
7. Tuning Control
8. Mp3 Input, Wire and Plug
9. Mp3 Wire Retaining Clip
10. Mp3 / Radio Switch
11.AM/FM Band Switch
12. Volume Control and Buzzer switch
13.PM Indicator
14.Alarm ON indicator
BOTTOM OF SET: Battery compartment for 9 volt battery (not included) for tempo-
rary timekeeping in event of power failure.
ANTENNA
For AM reception, this radio incorporates a built-in highly sensitive ferrite core bar
antenna.
For FM reception, this set is specially equipped with an FM antenna built into the
power line cord.
Be sure to untwist it to its fullest length for peak performance.
ELECTRONIC CLOCK OPERATION
1. Plug the AC line cord into 110/120V AC home outlet.
2. Put ON/OFF/AUTO switch (1) into the OFF position. The clock display will flash
to show you it is not set correctly.
3. To set the correct time, turn the dial (4) to "Set Time" position, then depress the
Hour Button (6), release the button when the correct hour is reached. Now
depress the Minute Button (5) to set the display to the correct minute. The PM
indicator (13) will be lighted when the clock is reading PM.Be sure PM is on if
current time is PM.
4. When the correct time is set, turn the dial (4) to "Clock" position. Time cannot
be changed when switch is in this position.

RADIO OPERATION

1. Slide the ON/OFF/AUTO Switch (1) to 'ON' position.
2. Slide the RADIO/MP3 switch (10) to RADIO position.
3. Slide Band Switch (11) to FM or AM position.
4. Turn the Volume Control (12) to desired volume.
5. Turn the Tuning Control (7) to select your favorite station.