Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SPRAY
Water can affect some fabrics. Test this out on a hidden part of the fabric.
1.
Lift the iron off the fabric.
2.
Aim the spray nozzle at the fabric.
3.
Press the
water through the system.
BURST OF STEAM
1.
Lift the iron off the fabric.
2.
Press the
3.
Leave 4 seconds between steam bursts to let the temperature build up.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing
fabrics.
•
Check that there's adequate ventilation behind the fabric, otherwise
moisture may build up, causing mildew.
•
Check that there's nothing behind the fabric that may be damaged
by the steam.
•
Check that pockets, turn-ups, and cuffs are empty.
1.
Hold the iron close to (but not touching) the fabric. Hold it well
away for delicate fabrics.
2.
Press the
3.
Leave 4 seconds between steam bursts to let the temperature build up.
AUTO SHUT-OFF
If the iron is motionless, it will switch off after about 30 seconds with the
soleplate down or on its side, or about 8 minutes if it's upright.
• Your iron will beep 6 times and the light will flash continuously until you
move the iron.
• To switch the iron on again, lift it up, tilt it forward, then sit it upright to
return to operating temperature.
AFTER USE
1. Set the steam control to
2. Unplug the iron.
3. Open the water inlet cover.
4. Hold the iron over a sink, turn it upside down and drain the water
from the reservoir.
5. Stand the iron on its heel and leave it to cool down completely.
6. When cold, wipe off any moisture and close the water inlet cover.
button – you may have to press it 2 or 3 times to pump
button.
button.
.
6
Publicidad
Tabla de contenido
