Maxon 289493-01G Instrucciones De Instalación página 14

NOTE:
below bracket, with each bolt.
4. Let liftgate hang with support from corner
posts of the pickup bed.
CAUTION
Before drilling holes in the pickup
bed, ensure there are no obstruc-
tions to drill bit or items that could
be damaged.
5. Hold RH mounting bracket against corner
post of the pickup bed (FIG. 14-1). Then,
use 2 bracket holes closest to front of
peat for LH mounting bracket.
6.
pickup bed as shown in FIG. 14-1. Re-
peat for LH mounting bracket.
7. Unlatch and unfold platform. Refer to C2
Operation Manual if needed. Then, ad-
just liftgate position so platform is level
from front to back.
8.
ing bracket to main frame bracket (FIG.
14-1). Ensure the split lock washers are not
in the slotted holes on main frame bracket.
Repeat for LH mounting bracket.
9. Check and ensure there is enough clearance
between the taillight lenses and liftgate.
10. Use upper hole in the RH mounting plate as a
template to drill hole through inner side of pick-
up bed (FIG. 14-1). Then, bolt RH mounting
plate to inner side wall of pickup bed as shown
in FIG. 14-1. Repeat for LH mounting plate.
LIFT CORPORATION Sht. 14 of 54 DSG#
INSTALLING LIFTGATE - Continued
(FIG. 14-1). Re-
M-14-26
3/8"-16 HEX BOLT
3/8" FLAT WASHER
3/8" LOCK WASHER
3/8" HEX NUT
(3 PLACES)
DRILL THESE 2
HOLES FIRST
3/8" FLAT WASHER
(IF NEEDED)
BRACKET
PLATE
BOLTING RH MOUNTING BRACKET
TO PICKUP BED (LIFTGATE NOT SHOWN)
-
Rev. E Date: 08/13/19
CORNER
RH MOUNTING
POST
BRACKET
HOLE LAST
FLOOR OF
PICKUP BED
FIG. 14-1
DRILL 1