To Start A Cold Engine; To Start A Warm Engine; To Trim The Grass - Husqvarna 122C Manual Del Usuario

4. Make sure that the air filter is not clogged.
5. Make sure that the safety devices on the product are
not defective.
6. Make sure that the product has no fuel leaks.

To start a cold engine

1. Push the air purge bulb 10 times.
2. Pull the choke control up.
3. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not step on the product.
4. Pull the starter rope handle slowly until you feel
some resistance. When you feel resistance, pull the
starter rope handle quickly and with force.
WARNING: Do not twist the starter rope
around your hand.
5. Continue to pull the starter rope handle until the
engine starts.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle. This can cause
12
damage to the product. Release the
starter rope slowly.
6. Set the choke control to the operation position and
apply full throttle. The throttle trigger automatically
disengages from the start position.

To start a warm engine

1. Push the air purge bulb 10 times.
2. Pull the starter rope until the engine starts.
To stop
• Push the stop switch to stop the engine.
Note: The stop switch automatically goes back to its
initial position.

To trim the grass

1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
1059 - 002 - 10.10.2019