Baby Jogger City Go Manual Del Usuario página 19

SEAT INSTALLATION - LAP/SHOULDER BELT ALT
1
2
3
4
line MUST be level
RED
with the ground when
installed in vehicle
WITHOUT the base.
Before installing carrier, make sure vehicle
is on level ground. Place carrier on an
approved vehicle seat location.
1 Place the car seat rear-facing on the
vehicle seat. Route the lap portion of the
lap/shoulder belt through the lap belt
guides on both sides of carrier. Make sure
the belt lies flat and is not twisted.
2 Fasten the buckle until it clicks into place.
3 Pull on shoulder portion toward the
retractor while pressing down on the
center of the carrier to tighten carrier to
vehicle seat.
No te: Check to make sure carrier is secure
by holding both sides near the lap belt
guides and moving it. The lap belt should
not loosen and the carrier should not
move more than 1 inch from side to side
or front to back.
4 After installing the carrier without base,
check the red level line on the label
beneath the handle to make sure that it
is level with the ground.
19