Problem Solution - Ratio AR144NM Manual De Instrucciones

System". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
15. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Lithium batteries. Consult your
local waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating your
drill, then remove the battery pack from the drill
housing and cover the battery pack connections
with heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt to
open or remove any of the components.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is
on top of the trigger, is positioned in the lock
function. Unlock the forward/reverse rotation
control by putting it into the required rotation
position. Push the trigger and the drill will start to
rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting
ring, you can find the torque-adjusting ring
between the chuck and the drill body. Position
1 is the lowest torque (screw driving force) and
position 18 is the highest torque (screw driving
force). Position is for drill operation. Regulate
the torque adjusting ring to a higher position to
reach the best result.
3. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot.
4. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and having
not used a battery pack for a prolonged time will
reduce the battery pack working time. This can
be corrected after several charge and discharge
operations by charging & working with your drill.
Heavy working conditions such as large screws
46
into hard wood will use up the battery pack
energy faster than lighter working conditions. Do
not re-charge your battery pack below 0
above 45 C as this will affect performance.
o
MANUTENÇÃO
A ferramenta não requer lubrificação adicional
nem manutenção.
Esta ferramenta elétrica não contém nenhuma
peça que possa ser reparada pelo utilizador.
Nunca use água ou produtos de limpeza
químicos para limpar a ferramenta. Limpe com
um pano seco. Guarde sempre a máquina num
local seco. Mantenha as ranhuras de ventilação
do motor limpas. Mantenha todos os botões
de utilização isentos de pó. Ocasionalmente
poderá ver faíscas através das ranhuras de
ventilação. Este facto é normal e não irá danificar
a máquina.
C and
o