Marmitek DOORPHONE 120 Modo De Empleo página 9

Follow the 5 steps given below for the pairing of the handset to the door unit.
Handset
Step 1
Press and hold the buttons (8) and (9)
at the same time for a few seconds
to put on the handset. You will now
hear a short beep. Release (8) and (9)
buttons and you will hear a 2nd beep
as confirmation.
Step 2
Step 3
Step 4
The 'P' symbol will stop
flashing when the ID code has
been received.
Step 5
After you hear the two confirmation
beeps of the door unit, press on
button (8) to go back to the normal
display.
The pairing procedure has now been completed. To test the pairing function, place the
batteries back into the door unit and press on the doorbell button (1). The handset should
respond now.
DOORPHONE 120™
Door unit
Set the dipswitch 3
on the 'Pairing'
position (7).
Place 4 AA-alkaline
batteries, keep in mind
the right poles + and -.
The doorbell indicator
light (2) shall now burn
constantly.
Now press on the
doorbell button (1) and
the 'Bell' light will start
flickering. A random
ID code is now being
generated and sent to
the handset.
Within 10 seconds,
the unit will beep
twice to indicate
that the handset has
received the ID code.
Take out the
batteries and put
the dipswitch (7)
back to the
'Normal' position.
9