sunjoe SJ1440SP Manual De Usuario página 5

Fig. 5
Locking tabs
6. Plug the other end of the solar charging output of the solar
panels. Positive branch connector to solar charging input
POSITIVE (+) terminal (Fig. 6).
Fig. 6
Solar charging output
(+) branch connector
7. Plug the negative branch connector to solar charging input
NEGATIVE (-) terminal (Fig. 7).
Fig. 7
Solar charging output
(-) branch connector
8. While the system is charging, the solar charging indicator
will be illuminated, the backlight will be illuminated for 5
seconds and the beeper will sound (Fig. 8).
Solar charging
Fig. 8
Charging
power
Solar Charging-Only Mode
Solar charging input
(+) terminal
Solar charging input
(-) terminal
Battery level
9. While in charging-only mode, no output loads/devices
are connected, only input power, battery level and solar
charging indicators will be displayed (Fig. 8).
10. To read the battery current voltage, turn the unit on.
Push and hold the ON/OFF button for approximately
1.5 seconds and release the button when the unit beeps
(Fig. 9).
Fig. 9
Battery current voltage
11. With direct sunlight, a typical 60 W solar panel may take
up to 60 hours to fully recharge the generator depending
on the intensity of the sunlight on the solar panel.
12. The battery indicator will display the battery level during
the charging stage.
13. To turn the unit off, press and hold the ON/OFF power
button for approximately 1.5 seconds, release when
the unit beeps. LCD display indicators will turn back to
charging-only mode.
14. To disconnect solar panels, depress locking tabs while
pulling connectors apart (Fig. 10).
Fig. 10
Locking tabs
5
Press and hold 1.5 seconds