Lesco ZeroPump Premium Elite Serie Manual De Uso Y Cuidado página 7

OPERATING INSTRUCTIONS CONTINUED
Door Latch
Battery Door Open Battery Orientation Battery Installed
Removing the Battery:
1. With the Sprayer on a stable surface set the Power Switch into the OFF (O) position.
2. Open the Battery Compartment by pushing down on the Door Latch located at the top of the Door,
and swing the Door open and downward.
3. Depress the Battery Button (located on the top rear surface of the Battery when installed) and lift the
Battery approximately 2 inches until it released from the Battery Dock.
4. Remove the Battery from the Battery Compartment.
5. See Cleaning & Storage section for Battery storage instructions.
6. See Charging the Battery for Battery charging instructions.
7. Close the Door and ensure that the Door Latch (located at the top of the Door) is engaged.
Powering-On and Spraying:
WARNING: RISK OF UNINTENDED SPRAYING AND CHEMICAL EXPOSURE. Ensure that the Shut-off
is in the closed position (Lever released) before setting the Power Switch to the ON (I) position.
The Sprayer will spray if the Shut-off is open (Lever depressed) when the Power Switch is set to the
ON (I) position. Only spray when the air is calm (no wind or air movement) to prevent chemical
spray from drifting into unintended areas.
1. A Battery must first be inserted into the Battery Dock in the Battery compartment for the Sprayer to
operate. Follow the instructions for Inserting the Battery.
2. Set the Power Switch into the ON (I) position. If the Sprayer has not been used recently there will
probably be a low, audible hum, indicating the Pump has turned on and is building pressure in the
Hoses. If the Sprayer was used recently, and still has pressure in the Hoses, the Pump may not turn on
until the Shut-off is opened (Lever depressed).
3. Aim the Wand in the desired direction of spraying and depress the Shut-off Lever.
4. For continuous spraying, depress the Lever and rotate the Lock to hold the Lever in the depressed
position.
5. Unlock, if needed, and release the Shut-off Lever to stop spraying.
6. To turn off the Sprayer set the Power Switch into the OFF (O) position.
7. Always remove any chemical, and clean the Sprayer when finished use. See Cleaning and Storage.
Page 7