Troubleshooting - Black+Decker MATRIX BDEDMT Manual De Instrucciones

reverse control button to the right.
NoTe: When changing the position of the
control button, be sure the trigger is released.
INSTAllING ANd ReMovING Tool
ATTAchMeNTS - fIGuRe A
WARNING
: Shock hazard. Under no
circumstances should this product be used near
water.
WARNING:
burn hazard. Moving parts
within the Power Unit become hot during use.
Avoid contact with moving parts within Power
Unit when removing and installing
accessories.
WARNING
: To reduce the risk of injury,
turn off and unplug the tool before making any
adjustments or removing or installing
attachments or accessories. Remove any
accessory from the tool attachment before
removing or installing the attachment.
WARNING:
To reduce the risk of injury,
do not place fingers or any other object inside
the Power Unit, other than the attachments
designed to work with the Power Unit.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BlACk+DECkER help line at 1-800-544-6986.
oN-boARd ScReWdRIveR bIT SToRAGe
(bIT NoT INcluded)
A bit storage slot (4) is built-in to the handle of
the Power Unit for easy bit storage and access.
MAINTeNANce
Use only mild soap and damp cloth to clean
the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual)
should be performed by authorized service

Troubleshooting

Possible cause
• Cord not plugged in.
• Forward/reverse slider not fully
depressed in desired direction.
• Circuit breaker is tripped.
• Cord or switch is damaged.
• Attachment is not secured.
• To remove an attachment, depress the release
button (3) and take the attachment off the tool.
• To fit an attachment, line it up with the tool as
shown and push it onto the Power Unit until it
snaps into place and an audible click is heard.
• Ensure attachment is securely attached by
gently pulling it away from the Power Unit.
NoTe: Only use attachments that are spe-
cifically designed for and compatible with
the Power Unit.
NoTe: Refer to individual attachment
instruction manuals for specific safety
warnings and operating instructions before
operating attachments with the Power Unit.
A
Possible Solution
• Plug tool into a working outlet.
• Push slider completely to
the left or right.
• Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have it
serviced at a BlACk+DECkER
service center or
authorized servicer.)
• Have cord or switch
replaced at BlACk+DECkER
Service Center or
Authorized Servicer.
• Make certain the attachment is fully
pushed into the Power Unit.
centers or other qualified service personnel,
always using identical replacement parts.
AcceSSoRIeS
WARNING:
recommended for use with this tool could be
hazardous.
Recommended accessories for use with
your tool are available from your local dealer
or authorized service center. If you need
assistance regarding accessories, please call:
1-800-544-6986.
5
The use of any accessory not