Proper Positioning On Vehicle Seat; Securing The Child - Diono monterey 4 DXT Manual De Instrucciones

PROPER POSITIONING ON VEHICLE SEAT

Place booster seat on vehicle seat so it is resting
firmly on vehicle seat bottom and touching the
vehicle seat back.
IMPORTANT: When using the booster seat as a
high-back booster, try to position backrest in full
contact with vehicle seat back.
It may also be necessary to adjust the recline angle of the booster
seat to match that of the vehicle seat.
ADJUSTING THE RECLINE ANGLE
This booster seat features a recline angle that can adjust to match
that of the vehicle seat:
1. Push booster seat backrest backwards until you
hear a click. Backrest will now pivot freely and
does not need to click into another position.
2. Push seat bottom and backrest of booster
seat down and back into vehicle seat until
there is secure positioning and full contact
with the booster seat and vehicle seat bottom
and vehicle seat back.
12
01827 310557
1. Make sure booster seat is properly positioned and
installed on vehicle seat as per the instructions.
2. Properly position child: sitting upright and all
the way back in the booster seat.
3. Make sure booster seat backrest width is adjusted
to narrowest width setting that comfortably fits
child. Raise the headrest to access upper belt
guides. Feed the diagonal portion of the seat belt
through the upper belt guide on the side
opposite the seat belt buckle.
4. Fasten seat belt across child: Lap portion of
seat belt should rest within both red lower belt
guides. Diagonal shoulder portion should route
inside the red lower belt guide closest to the
buckle and over child's shoulder.
5. Adjust headrest to proper height: Upper shoulder
guide should be slightly above (at least 1 cm)
the child's shoulders.
WARNING:
If headrest is adjusted to maximum height
and child's shoulder height is closer than 1 cm to the
upper belt guide, child is too tall for booster.

SECURING THE CHILD

1
2
3
4
diono.com
Click!
13