Function Description - RS Pro AT-8 Manual De Instrucciones

Contact and non-contact tachometer / English
Press the "MEAS" button .Point the laser spot at the object or bring the contact probe to
the object .Then read the measurement on the LCD display.

4. Function Description

In scan mode, the current measurement is displayed on the main display. The main display
will hold the last values until the tachometer automatically turns off.
Data Storage: Press the "MEAS" button until the reading displayed on the LCD display.
Observe the reading and press the "MEM" bottonto record. The maximum,minimum,average
and data during one shot measurement will be stored into a memory set. Then the Data
numer will increase by one.
Recall Data: Use the "MEM" botton to scroll and view the stored data point. Press the "MEM"
button once to next storage,you will view the MAX measurements, MIN measurements, AVG
measurements and DATA measurements. Press the "MEM" button and don't to release it to
leap to next Data Set.You will view Data0 to Data9 ,10 selectable Data measurements.
Press the "MEM" button once to nex storage
Data0 MAX Data0
Data1 MAX Data1
Data9 MAX Data9
Press the "MEM" button and don't to release it
Data0 MAX Data0
Data1 MAX Data1
Data9 MAX Data9
2
[ chart 1 ]
MIN Data0 AVG Data0
MIN Data1 AVG Data1
MIN Data9 AVG Data9
[ chart 2 ]
MIN Data0 AVG Data0
MIN Data1 AVG Data1
MIN Data9 AVG Data9
Measurement Mode Switch: Release the "MEAS" button and press the "MODE" button
before the instrument auto power off(released the "MEAS" button this instrument will auto
power off in 15 sec).There are two group of measurement. You can press the "MODE" button
once to change from RPM,rpm,HZ,....to the next sequentially. Press the "MODE" button and
hold for approx.3 sec to leap to the next group .Then you can press the "MODE" button once
to change from REV,M,In....to the next sequentially. Selected the mode of you need, depress
the "MEAS" start measures.
Measurement Mode Switch
RPM
rpm
HZ
M/N
I/M
F/M
Y/M
RPM: Non-Contact revolutions per minute measurements.
rpm: Contact revolutions per minute measurements.
HZ : Non-Contact /Contact frequency measurements.
M/M: Contact Meter per minute measurements.
I/M: Contact Inch per minute measurements.
F/M : Contact Feet per minute measurements.
Y/M: Contact Yard per minute measurements.
REV: Revolution measurements.
M : Length measurements in the uit of meter.(Using the master 10cm circumference wheel.)
In : Length measurements in the uit of inch. (Using the master 10cm circumference wheel.)
FT : Length measurements in the uit of feet. (Using the master 10cm circumference wheel.)
Yd : Length measurements in the uit of yard. (Using the master 10cm circumference wheel.)
Contact and non-contact tachometer / English
[ chart 3 ]
Press for 3 sec
REV
M
In
FT
Yd
3