Motion Concepts MaTRx PB-Elite Instrucciones De Instalación

Installation Instructions:
MaTRx PB-Elite Headrest Mounting Plate
MaTRx PB-Elite Headrest Mounting Plate
1.0 Installation Overview
Tools Required:
w Phillips Screwdriver
w 8
mm
Wrench
w Grease Pen or Marker
w Power Drill
Important! There are 3 uniquely designed Headrest Mounting Plates for the MaTRx PB-Elite
back. The appropriate headrest plate is determined by the width of the backpan (as illustrated in Figure
1.0 below). The mounting location for the headrest plate may also vary depending on the back height
(please see Section 2.0, p.2). The following installation instructions are provided as a guideline
for locating and installing the headrest mounting plate.
Figure 1.0
FOR ELITE BACKS-
(Small)
TRX3995
12"W (31cm)
(Medium)
TRX3938
FOR ELITE BACKS-
13"W - 17"W
(33cm - 43cm)
- 1 -
w 13/64" or 5mm Drill Bit
w Small Level
w C-Clamp/ Vice Grips
EN
(Large)
TRX3939
FOR ELITE BACKS
18"W & UP (46cm+)
TRD0228-04