Package Contents; Squeegee Installation; Solution Tank - Global Industrial 641250 Manual Del Usuario

WARNING
• Do not operate machine unless you have read
and understand this manual.
• Do not use your fingers to wipe or remove debris
from the blades, as injury may occur.
• Flammable materials can cause an explosion or
fire. DO NOT use flammable materials in tanks as
cleaning agent.
• Always empty Recovery tank before filling

solution tank

• Always empty and clean the recovery tank after
using the machine.
• Do not fill the solution tank before emptying the
recovery tank
• Before performing any maintenance on the
machine, be sure that the power is turned off.
• Repairs are to be completed by Authorized
Person-nel/Service Centers only.
• Do not put any flammable materials into
solution tank. This can cause an explosion or
a fire. Only use approved cleaning chemicals.
Contact Global Industrial (1-800-645-1232) for
recommendations on proper Cleaning Solutions.
• Foam must not enter the float shut-off screen, or
damage can occur to the vacuum motor. Foam
will not activate the machine's float shut-off
device.

PACKAGE CONTENTS

1. Machine
2. Squeegee Assembly
3. Pad Driver
MACHINE SET-UP/OPERATION PRIOR TO EACH USE
1. Always plug into grounded outlet rated 120V/60HZ/20A.
2. Check that squeeze assembly is properly installed.
3. Check that the pad driver is properly installed.
4. The working surface is sufficient to support the weight
of the machine.
5. Always close Recovery Tank cover fully before use
GFCI (GROUND CIRCUIT INTERRUPTER) PLUG
WARNING
Before use should be tested to verify that the GFCI
plug can work properly.
, as injury may occur.
• Connect the GFCI plug to the wall outlet
• Press the "rest button", the plug indicator light
will be on , then press "test button", the indicator
light will be off with the "click" (trip) sound. Power
will be off at this lime.
• This test is complete and ready to be used.
18" Electric Auto
Floor Scrubber

SQUEEGEE INSTALLATION

• Loosen the 2 knobs on the squeegee assembly.
• Connect the vacuum hose to the vacuum hole in the
squeegee assembly.
• Align the knobs with the slots and tighten the knobs.
PAD DIVER/BRUSH INSTALLATION
1. Machine 2. Squeegee Assembly 3. Pad Driver
4. Battery 5. Charger
• Disconnect Power
• Place the pad driver/Brush under the head assembly.
• Lower the head assembly to the floor by stepping on
the foot pedal and disengaging it
• Line up three studs on the pad driver/brush to the holes
on the head assembly and lock it by turning clockwise.
• Press Pad Driver/Brush button on so that the pad
driver/brush locks in completely
• To remove the pad driver/brush, disconnect the
power and wiggle the pad driver/brush back and forth
clockwise/coun terclockwise until it becomes loose.
• If using a pad driver, first attach the appropriate pad to
the pad driver surface
SOLUTION TANK
• Check water level indicator
for water level
3
Knob
Vacuum Hose
DISENGAGED
PEDAL
• Remove the solution tank cap and fill
with clean water for regular cleaning
surface. For deep and dirty surface,
Contact Global Industrial (1-800-
645-1232) for recom mendations on
proper Cleaning Solutions.
User's Manual User's Manual User's Manual
Knob