Publicidad
Idiomas disponibles
Idiomas disponibles
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the Eu-
ropean Commission, which came into force as
from January 1
, 2015 , our products have been
st
adapted to comply with these new requirements.
All of the models complying with the energy label
requirements, are equipped with new electronics
including a timer device for suction speeds con-
trol, when the air capacity exceeds 650m³/h.
Internal motor models, with maximum air capacity
higher than 650m³/h, are equipped with a timer de-
vice that automatically switches the suction speed
from 4
to 3
speed, after 5 minutes operation.
th
rd
External motor models are equipped with remote
motors that , as for internal motor versions, inclu-
de a timer device that switches down the suction
speed when it exceeds 650 mᵌ/h. (See External
Motors Instructions).
Remote motors, whose air capacity exceeds
650m³/h at both 4
and 3
th
following by default timer control functions: The
suction speed is automatically switched from 4
2
speed, after 6 minutes operation.
nd
If the appliance is working at 3
matically switched to 2
operation. Operation speeds can also be changed
during operation.
The energy consumption of the appliance in stand
– by mode is lower than 0.5W.
speed , will have the
rd
speed, it is auto-
rd
speed, after 7 minutes
nd
MAINTENANCE
* An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
* Particular care is due to the grease filter panel. It
can be removed by pushing its special handle to-
ward the back-side of the cooker hood and turning
the filter downwards so to unfasten it from its slot.
To insert the filter just perform the opposite ope-
ration.
After 30 hours working, the push button control
panel will signal the saturation of the grease filter
by lighting all the buttons. Press the timer button
to reset .
The grease filter needs cleaning by regular hand-
washing or in dishwashers every two months at
to
th
least or depending on its use.
* In case the appliance is used in its filtering ver-
sion, the active coal filter needs to be periodically
replaced. The coal filter can be removed by remo-
ving the grease filter first, and by pulling its special
plastic tongue until it is unfastened from its slot.
Re-insert the coal filter by operating in the opposi-
te way. The coal filter needs replacing depending
on the use, but however every six months at least.
* To clean the appliance itself tepid water and neu-
tral detergent are recommended, while abrasive
products should be avoided. For steel appliances
specialized detergents are recommended (please
follow the instructions indicated o the product itself
to obtain the desired results).
Before to replace the led lamp switch off the ap
pliance then by using appropriate tools remove
the led lamp from its slot (Pic. 9).
Take out the led lamp from its connector and re
place with similar characteristics.
To find the correct led lamp please check on the
replacement part list.
* If the supply cord is damaged, it must be repla-
ced by the manufacturer or its sevice agent or a si-
milarly qualified person in order to avoid a hazard.
15
Publicidad
