On The Status Display; Menu Configuration; First Time Installation; The Operation Procedure - JVC DT-V9L5 Manual De Instrucciones

Showing Input Signals (cont.)

On the Status Display

If you press the INPUT SELECT button (☞ 9 on page 10) currently lit, the status of the input signal and setting of MUTING are displayed for about
3 seconds.
●
Make the setting to display/hide the status in "Status Display" of the "Information". (☞ page 20)
●
When "Status Display" is set to "Auto" or "On," the status below is also displayed in the following cases:
– When you change the input
– When the signal condition of the current input changes
– When you turn on the monitor
●
When "Status Display" is set to "On," the signal format will remain displayed 3 seconds after the status is
displayed.
1 Signal format
●
For the contents displayed, see "Available signals" on page 30 and "On the signal format" below.
On the signal format
The following messages appear depending on the type of input signals and their conditions.
When a HDMI signal protected with HDCP is input
When no video signal comes in
When a noncompliant video signal comes in
2 Signal format of HDMI and VIDEO/COMPONENT input
3 Setting of "MUTING"
• Only appears when in mute mode. (☞ 5 on page 10)

Menu Configuration

First Time Installation

When you turn on the power and the monitor, "First Time Installation" appears.
Start setting referring to the menu configuration.
For the setting items, see the pages below.
☞ "Language" on page 20
•
"Language"
☞ "Sync Function" on page 18
•
"No Sync Action"
☞ "No Operation Action" on page 18
•
"No Operation Action"
Setting procedure
1
Press to move the cursor to the setting item
2
Press to select the setting values
●
Each time you press one of these buttons, the setting value changes.
3
Move the cursor to "Set"
4
Press to finish setting
●
When you change the settings, a confirmation message appears.
Operate according to directions.

The operation procedure

1
Press the MENU button to display the Main Menu
To display the Main Menu
➡ Press the MENU button.
To display the Set-Up Menu
➡ Press the
button while holding the
2
Use the buttons to select an item and press the
proceed to the next screen
3
Use the buttons to select an item and press the
proceed to the next screen
●
For some items, pressing the
4
Use the buttons to select an item and use the
to adjust the setting
5
Press the MENU button to finish operations
●
Press the MENU button repeatedly until the menu screen disappears.
12
➔
"*" (at the end of the indication)
➔
"No Sync"
➔
"Out of range"
button.
button to
button to
buttons adjusts the setting.
buttons
●
Once the settings have been adjusted, this screen will not appear
again.
●
The settings can be changed afterwards in Main Menu and Set-Up
Menu.
Main Menu
Selected item
Operation guide
●
The menu screen disappears automatically if no operations are
made for about 30 seconds.
●
Inoperable menus will be grayed out.
●
Some items will not be displayed on the menu depending on the
selected input and signal format.
Set-Up Menu
Ex.: When "Picture Function"
in the Main Menu is selected