Troubleshooting - BLACK&DECKER BDCS1806 Manual De Instrucciones

90537965 BD Circ Saws 5/30/08
MAINTENANCE
REMOVE BATTERY FROM SAW WHEN PERFORMING ANY CLEANING OR OTHER
MAINTENANCE.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations, always using identical
replacement parts
Accessories
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be
hazardous.
Model Blade Diameter
BDCS1806 6-1/2 inch (165mm)
BDCSL1806
BDGCS1806
BDCS2406
BDCS1807 7-1/4 inch (185mm)
Only use thin kerf blades. Using thicker blades will hamper performance of saw.
Carbide blades are strongly recommended for optimum saw performance. NEVER USE
ABRASIVE TYPE OR METAL CUTTING BLADES ON SAW.
Problem
• Unit will not start.
• Battery will not charge.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
10:11 AM Page 16

Troubleshooting

Possible Cause
• Battery not installed properly.
• Battery not charged.
• Battery not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
16
Possible Solution
• Check battery
installation.
• Check battery charging
requirements.
• Insert battery into
charger until red LED
appears.
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Move charger and tool to
a surrounding air
temperature of above 40
degrees F(4,5°C) or below
105 degrees F (+40,5°C).