Worx WX030L Manual Del Usuario página 10

OPERATING INSTRUCTIONS
NOTE: Please read the instructions carefully
before use.
INSTALLATION AND OPERATION
1. Installation of the Brush/Crevice Tool
Remove accessory from the storage port, connect to
the vacuum tube by pushing into place (See figure
A1)
NOTE: Crevice tool accessory can be stretched out
for usage (See figure A2)
2. Start/stop(See figure B)
Press the on-off switch to start the vacuum
operation.
When the switch is pressed for the first time, the
machine starts and works at low speed.
When the switch is pressed again, the machine
works at high speed.
When the switch is pressed for the third time, the
machine stops.
WARNING: Please keep the air intake
unobstructed, otherwise it may cause motor
overheating and may damage the machine.
3. Debris Emptying Cleaning( See figure
C1,C2)
Press the debris emptying button to open the dust
cup. Rotate the filter counter-clockwise to remove
10
and rinse in clean water when needed. To reinsert the
filter, rotate clockwise and lock filter element in place.
Warning: Do not use the vacuum without installing
the filter element. If the suction becomes decreased,
it is necessary to clean out the debris in the debris
collection container
4. Filter Cleaning
The filter is composed of the filter net cylinder and
the HEPA filter. Remove both and discard debris (see
figure D1). Both filters can be rinsed in clean water
and air dried. Replace HEPA filter inside Net cylinder
filter, rotate clockwise until locked. Locate three long
slots on HEPA filter and match those in the debris
collection container. Rotate clockwise to secure
connection prior to using. ( See figure D2)
Note: In order to maintain excellent suction, it is
recommended to change HEPA every three months.
MAINTENANCE
WARNING: Remove the battery before carrying out
any servicing or maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the
ventilation slots, this is normal and will not damage
your power tool.
20V Vacuum Cleaner
Operation instructions for the accessories
The brush is suitable for dust removal from
inaccessible corners in the interior of the car, such as
the bottom of the seat, the side of the seat, the inside
of the door, the area around the driver's seat, the rear
window, the trunk of the car, etc.
Remove soft thin brush and replace with:
The crevice tool can be used to clean most of the
cracks and corners of the car.
Precautions when using the machine
Cannot be used to absorb water.
Cannot be washed in water.
Check the hoses regularly and stop using if there is
any damage.
When cleaning or maintaining, remove the battery
pack.
STORAGE
Clean the moulded plastic housing of the machine
using a soft brush and clean cloth. Do not use water,
solvents or polishes. Remove all debris, especially
from the motor cooling vents.
Store in a secure, dry place out of the reach of
children.
Do not place other objects on the product.
FOR BATTERY TOOLS:
The ambient temperature range for tool and battery
use and storage is 0 C-45
o
The recommended ambient temperature range for
the charging system during charging is 0
C.
o
C-40 C.
o o
EN