Hoover PROFESSIONAL Serie Manual Del Usuario página 21

PROBLEM POSSIBLE CAUSE
Cleaner won't run 1. Not firmly plugged in
2. No voltage in wall plug
3. Blown fuse or tripped breaker
4. Fuse in cleaner blown
Low suction 1. Dirty Water Tank full/automatic shut
off engaged
2. Dirty Water Cap or Plug not on
correctly
3. Dirty Water Tank Debris Filter Clogged 3. See "How to Clean" page 12
4. Blockage in nozzle
5. Recovery Tank not properly secured
6. Clogged Filter
Clean water won't 1. Clean Water Tank not firmly in place
dispense
2. Clean Water Tank or solution
container empty
Brushes won't
rotate during floor
cleaning
POSSIBLE SOLUTION
1. Plug unit in firmly
2. Check fuse or breaker in home
3. Replace fuse or reset breaker in home
4. Take to service center
1. Remove and empty Dirty Water Tank.
See "How to Empty" page 12
2. Tighten
4. See "How to Clean" page 13
5. Replace Recovery Tank and secure
recovery tank latch
6. Clean it
1. Make sure tank is securely locked in
position
2. Refill container according to cleaning
instructions
3. Ensure trigger is being pulled
Check for jams and/or broken belt
21