Using The Device - Work Pro W Light Mouse Serie Guia De Inicio Rapido

EN
6. Setting the network options
The device is Plug and Play. This means that it is able to autoconfigure it self to work in any
network. It achieves this by several ways:
LM 3R is automatically configured, which means that it obtains automatically an IP address
●
2.X.X.X and a Subnet Mask 255.0.0.0, just as Art-Net protocol specifies. However, for
advanced users, network configuration can be modified using the web browse interface, as
seen belowin the next point (7. Webserver configuration).
● If the network has got a DHCP server, then the device will take the IP address and subnet
mask given by the server.
● If the network hasn't got a DHCP server, then the device gets an automatic IP following the
ZeroConf protocol, this is, it takes an IP address in the range 169.254.X.X and a subnet
mask of 255.255.0.0. Any local device, independent of its IP and subnet mask can access
to this kind of IPs, so no further configuration is required. If there is no DHCP server, the
startup time will be increased to around 30 seconds, because the device is waiting for the
response of a DHCP server.

7. Using the device

In Art -NET mode, the device can be controlled by any software capable of generate Art-NET, i.e.
Chamsys MagicQ or using a DMX to ArtNet interface as LM 3E.
In all cases, use the SubNet/Universe switches (7) to set the device according to the right connection
and the chosen universe to be controlled.
8. 1 Using LM 3E as ArtNet generator
LM 3E is a DMX to ArtNet interface able to convert DMX frame and send this information through
LAN network. This information can be received by one LM 3R2 configured in the same Subnet.
Depending on the installation, it is possible to configure several LM 3E with different universes in the
same SubNet and setting one LM 3R2 to receive 2 consecutive universes.
LM 3R2
User Manual/Manual de Uso
- 4 -