Descargar Imprimir esta página

Peavey EuroSys 700 Instrucciones De Uso página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

EuroSys™ 700™ & 800™
Thank you for choosing Peavey's new EuroSys series enclosures as part of your sound reinforcement system. We
take great pride in the design and manufacture of our units and you can expect top performance and reliability. Your
EuroSys enclosure has been rigorously tested before packing and dispatch to your dealer. The EuroSys enclosures
are a nominal 4 ohms impedance and are equipped with a full range high power passive crossover incorporating a
horn limiter.
Connection:-
The EuroSys series enclosures are equipped with 2 x combo/jack Speakon®-compatible sockets. The two sockets
are connected in parallel to provide a convenient connection to a further enclosure. (Note that the total load will
then be 2 ohms). The two combo/jack Speakon®-compatible sockets allow use with either 6.3mm jack plugs and or
Speakon® compatible plugs. When using the Speakon compatible plug wire the positive to 1+ and the negative to
1-.
Grille removal:-
In the unlikely event that access is required to the drivers the grille needs to be removed by releasing it from either of
the enclosure sides. There are no grille fixing screws. Lay the enclosure on its back and using two small screwdrivers
or similar hand tools carefully pushed into the grille holes near the opposite opposing corners, ease the grille towards
you. The grille will give allowing its removal. Do not attempt to prise or lever out the grille as this will result in damage
to the paint finish on both the grille and the enclosure.
Specification:-
EuroSys 700
350 Watts RMS (700 Watts program allowing for 3dB of headroom)
4 Ohms.
12" (305mm) premium woofer.
175T compression driver.
Dispersion: 90° x 45°.
Compression driver limiter
Frequency response: 65 Hz – 18.5kHz.
Efficiency: 96dB.
2 x Combo/jack Speakon®-compatible sockets
Dimensions (HxWxD): 22'' (560mm) x 17.5'' (445mm) x 15.2'' (385mm)
Weight : 47 lbs (21.5kg)
DANGER! LOUDSPEAKER CABLES CARRY HAZARDOUS VOLTAGES. TAKE CARE IN TERMINATING YOUR
CABLES. PEAVEY STRONGLY RECOMMENDS THAT THE POWER AMPLIFIER IS SWITCHED OFF WHILST
CONNECTING OR DISCONNECTING EITHER END OF THE LOUDSPEAKER CABLE.
DANGER! THIS ENCLOSURE HAS NOT BEEN DESIGNED TO BE FLOWN IN ANY WAY. NEVER ATTEMPT TO
SUSPEND USING THE HANDLES OR BY ANY OTHER MEANS.
CAUTION ! THIS LOUDSPEAKER ENCLOSURE IS CAPABLE OF HIGH SOUND PRESSURE LEVELS. USE
EXTREME CARE IN SETTING MAXIMUM LOUDNESS TO PREVENT POSSIBLE HEARING DAMAGE.
IN CASE OF DIFFICULTY CONSULT YOUR AUTHORISED PEAVEY DEALER
Due to our policy of continuing development, features and specifications are subject to change without notice.
Designed in the UK, built in China to Peavey's exacting standard and quality procedures.
Great Folds Road, Oakley Hay, Corby, Northamptonshire, NN18 9ET, England
ENGLISH
PEAVEY ELECTRONICS LIMITED
Tel: +44 (0) 1536 461234
Registered in the UK No. 1249126
EuroSys 800
400 Watts RMS (800 Watts program allowing for 3dB of headroom)
4 Ohms.
15" (381mm) premium woofer.
175T compression driver.
Dispersion: 90° x 45°.
Compression driver limiter
Frequency response: 60 Hz – 18.5 kHz.
Efficiency: 97dB.
2 x Combo/jack Speakon®-compatible sockets
Dimensions (HxWxD): 25.1'' (638mm) x 18.4'' (468mm) x 16.5'' (420mm)
Weight: 54 lbs (24.5 kg)
Fax: Fax: +44 (0) 1536 747222
09/03/09

Publicidad

loading

Este manual también es adecuado para:

Eurosys 800