Juiceman JM400 Instrucciones De Uso página 4

3. Place the lid on the juice bowl so that the pulp
opening is positioned over the pulp spout. Position
the back of the lid over the edges of the pulp spout
first; then lower the lid to fit firmly against the base
(D).
D
4. Center feed chute over lid opening so that the
safety lock hook on the feed tube is slightly to
the right of the arrow on the lid. Insert three tabs
located around bottom of the feed tube into the
three slots on the lid. Turn counterclockwise until
the safety lock hook on feed chute aligns with the
arrow on the lid (E).
E
5. Engage the safety locking lever with the safety lock
hook on the feed tube (F). You should hear a click
as it locks in place.
Important: Your juice extractor will not operate if the
safety locking lever is not properly locked.
F
6. Tilt the pulp container slightly and place it directly
beneath the pulp opening. Push the bottom of pulp
container inward so top edge slides up, behind the
pulp spout. Continue to press firmly on the bottom
of the pulp container until it fits snugly against the
base (G). When correctly positioned, pulp container
will be completely covered by the pulp opening in
the lid.
Tip: To make cleaning easier, you may wish to line the
pulp container with a small plastic bag to catch the
pulp as you juice.
G
Important: Your juice extractor will not operate unless the pulp container is
correctly placed.
6
7. Place the froth separator into the juice pitcher,
then place the lid on top. Position the pitcher
beneath the juice spout. Be sure that the juice
spout empties into the larger opening in the pitcher
lid (H).
H
8. Keep the food pusher in the feed chute until you are
ready to juice. To insert, rotate the food pusher until
the groove on the food pusher is properly aligned
with the ridge in the feed chute (J).
J
DISASSEMBLING YOUR JUICE EXTRACTOR
Important: Always make sure your juice extractor is unplugged before starting
to disassemble.
1. Press down on safety lock button, swing safety
locking lever away from feed tube. Release safety
lock button (K).
K
2. Unlock the feed chute by rotating it clockwise to
remove it from the lid (L).
L
7