Installing The Microphone - N-Com MCS II Seguridad E Instrucciones

ONLY FOR FULL-FACE HELMETS
Remove the chin guard by pulling on the special red tab.
Fig. 7
3.1.

Installing the microphone

JET HELMETS OR FLIP-UP HELMETS
Prepare the microphone by inserting the microphone clamp, being

careful to position it properly (Fig. 8)
Note: the flat part of the clamp must be facing upward when the
microphone is positioned as shown in figure 9.
Remove

polystyrene cheek pads by gently
pulling them out of the helmet.
The helmet shell can be opened
slightly to facilitate the removal of
the cheek pad .
Caution: In case the polystyrene cheek
pad is damaged during this operation,
turn to your
replacement.
the right and
local dealer
left
for its
9