EAS ELECTRIC EMSS188W Manual De Instrucciones página 36

Problem
A layer of frost occurs in food is placed within the appliance to allow sufficient
the compartment
T emperatura inside is
too warm
Temperatura inside is
too cold
Doors cant be closed
easily
Water drips on the floor
The light is not working
FAULT DISPLAY
Fault display shows as following under Fault mode:
ERRORCODE
uc
RS
ES
FS
Fd
FF
FH
Possible cause & Solution
Check that the air outlets are not blocked by food and ensure
ventilation. Ensure that door is fully closed. To remove the
frost, please refer to cleaning and care chapter.
You may have left the doors open too long or too frequently; or
the doors are kept open by sorne obstacle; or the appliance is
located with insufficient clearance at the sides, back and top
lncrease the temperatura by following the "Display controls"
chapter.
Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self close, or if something inside
is preventing the doors from closing.
The water pan (located at the rear bottom of the cabinet) may
not be properly leveled, or the draining spout
undemeath the top of the compressor depot)
properly positioned to direct water into this pan, or the water
spout is blocked. You may need to pull the refrigerator away
from the wall to check the pan and spout.
•The LED light may be damaged. Refer to replace LED lights
in cleaning and care chapter.
• The control system has disabled the lights due to the door
being kept open too long, close and reopens the door to
reactivate the lights.
Communication failure
Sensor failure (refrigerating chamber)
Failure of ambient temperatura sensor
Sensor failure (freezing chamber)
Defrosting sensor failure
16
ERRORTYPE
Fan failure
Defrosting failure
( located
may not be
'
V.1