Add Engine Oil And Fuel; Lubricate O-Rings - Power Boss Briggs & Stratton Manual Del Operario

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
NOTICE Any attempt to crank or start the
engine before it has been properly filled with the
recommended oil will result in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil
and fuel recommendations and instructions.
NOTICE Check oil often during engine break–in. Refer
to engine operator's manual for recommendations.

Lubricate O-Rings

Lubrication of o-rings is extremely important for
installation and operation. The use of a lubricant
(petroleum or synthetic grease) during assembly helps
seat o-rings properly and provides an improved seal. It
also helps protect the o-ring from damage by abrasion,
pinching or cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant
on o-rings prior to assembling the garden hose to the
pump (A), high pressure hose (B), spray gun (C), and
nozzle extension (D).
Lubricate all connections shown below, following
these instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light
film is all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible
(QC fitting, M22 fitting).
C
D
B
A
7