DeWalt DW624 Manual De Instrucciones página 10

328521-01/DW624 9/6/01 8:00 AM
Depth Stop Control Knob shown in Figure 9.
4 . Rotate the turret stop to position the shortest screw under the
depth stop bar.
5 . Raise the plunge release lever and push the router down until
the end of the bit just touches the workpiece.
6 . Lower the depth stop bar until the knurled knob on the bottom
of it touches the selected screw in the turret stop.
7 . Raise or lower the plastic vernier to align the hairline in the
vernier with the 0 mark on the graduated scale, as shown in
Figure 8.
8 . Using the depth stop control knob, raise the depth stop bar and
align the desired mark on the graduated scale with the hairline
in the vernier, as shown in Figure 9. (Scale graduated in
1/16ths of an inch)
9 . Tighten the depth stop bar clamp.
10.The router is now set to cut to the set depth when plunged into
the workpiece.
Fine Adjustment of Routing Depth
TURN OFF AND UNPLUG ROUTER.
If, after setting the desired depth of cut, a small adjustment is
needed, it is not necessary to go through the entire procedure for
setting the depth. Minor adjustment can be easily made by
rotating the knurled knob on the bottom end of the depth stop bar,
as shown in Figure 8.
Rotating the knob clockwise (looking down from the top of the
router) will result in a more shallow cut. Rotating the knob
counterclockwise will result in a deeper cut. One complete rotation
of the knob represents about 1 mm in depth adjustment.
Page 6
FIG. 4
BOTTOM OF
COLLET
HEIGHT STOP
QUICK
HEIGHT
THUMB
RELEASE
STOP
WHEEL
BUTTON
ROD
FIG. 6
TURRET STOP
6
FIG. 5
DEPTH
STOP
TURRET
STOP
FIG. 7
DEPTH
STOP BAR
VERNIER
KNURLED
KNOB
SPRING