Soundcore Liberty Air 2 Pro Manual De Usuario página 8

Play/Pause
Answer a call
End/Reject a call
Activate Siri or other voice assistant software
All of the controls in stereo mode can be customized in the Soundcore app. In
•
mono mode, controls cannot be customized in the app.
Music playback will auto-pause when removing the earbuds, wear them again to
•
resume.
Adjust the volume level via the connected device or in the Soundcore app.
•
In stereo mode, noise cancellation mode is set by default. Each time you power
•
on and connect, or switch to the stereo mode from mono mode, your earbuds
will restore the last setting.
Noise cancellation or transparency mode is unavailable in mono mode.
•
Reset
You might need to reset your earbuds if you experience any connectivity problems
or function issues.
1. Place the earbuds in the charging case and leave the case open.
2. Press and hold the button on the case for 10 seconds until the earbud LED
indicators flash red 3 times and then turn white.
3. Wait until the LED indicator on one of the earbuds flashes fast while the other
breathes slowly. This confirms that the reset was successful and your earbuds can be
connected normally.
1
The following two examples indicate the reset has not been successful and the
previous steps should be repeated.
Mono mode
Tap twice
Press and hold for 2 seconds
2 3
3
EN 06