Maintenance, Cleaning And Troubleshooting; Transport And Storage - Cross Tools TRAVELBOX 500+ Instrucciones Para El Manejo

Certain devices that vary in power consumption depending on the operating status or
with reactive power compensation might not be able to operate even if the specified
nominal power is less than 500 W.
When using extension cables or mobile distribution networks, a maximum length of
60 m must not be exceeded for a cross-sectional area of 1.5 mm
must not be exceeded for a cross-sectional area of 2.5 mm
tension cables only, which corresponds to the brief design description H07RN-F.

6. Maintenance, cleaning and troubleshooting

The device must not be cleaned using water or aggressive liquids. We
recommend cleaning the device with a dry and dust-free cloth.
The housing of the TRAVELBOX must only be opened by qualified per-
sonnel and any necessary repairs must only be carried out by qualified
personnel.
Fault
1. The connected 1. ON/OFF switch for the respective
devices are not output (AC / DC) is not switched on.
supplied with 2. Overload protection has triggered.
power.
3. Battery charge of the TRAVELBOX
too low.
4. Connected device defective.
5. TRAVELBOX defective
2. The TRAVEL- 1. The technical parameters of the con-
BOX will not ac- nected power source lie outside the
cept a charge required specifications.
2. Charging cable defective or incor-
rectly polarised.
3. TRAVELBOX defective

7. Transport and storage

Warning! Set both ON/OFF switches to "OFF" when transporting the de-
vice.
Preparation for longer-term decommissioning / storage of the device:
7. Make sure that the storage area is free from humidity and dust.
8. Do not store the device fully discharged. There is a danger of a deep discharge.
The optimum charge level for storage is approx. 50 %.
9. The switches on the device should be set to "OFF".
10. The ambient temperature should be approx. 20 °C.
11. The charging state should be regularly checked (at least every 2 months) and if
necessary recharged to approx. 50 %.
18
Possible cause
8
Translation of the original operating instructions
2
. A length of 100 m
2
. Use flexible rubber ex-
Remedy
1. Set the corresponding switch to "I".
2. Check the total power of the connect-
ed devices, this must not exceed 500
W in any operating state.
3. Check the charge level, recharge if
necessary.
4. Contact the customer service depart-
ment for the device in question.
5. Contact the customer service depart-
ment
1. Check the technical data of the power
source, use alternative charging op-
tions if necessary.
2. Replace charging cable or switch to
an alternative charging method.
3. Contact the customer service depart-
ment