Operation Tips - Worx WA0223 Manual Del Usuario

COMPONENT LIST
1. DEBRIS FLAP
2. BLADE
3. BLADE HOUSING
4. BLADE NUT
6
5. BLADE GUARD
6. GUIDE WHEEL
7. ADJUSTING KNOB
Not all the accessories illustrated or described
are included in standard delivery.
TECHNICAL DATA
Cutting depth
Cutting diameter
Machine weight
ACCESSORIES
Wrench
Hex key
Only use the appropriate accessories intended for
Edger Attachment
Remove battery from the
socket before carrying out
any adjustment, servicing or
maintenance.
POSITEC Inc. has established
a partnership with the RBRC
Corporation to recycle any
Positec batteries with the
RBRC-call2recycle seal. For
environmental protection,
please do not discard batteries
in the trash. After the batteries'
life cycle is ended, then please
call 1-800-822-8837 for a free
service that will properly
dispose of the battery.
WA0223
up to 2.5''(64mm)
8''(20cm)
4.21lbs (1.91kg)
WA0223
1
1
this tool. Accessory information can be found on
the product packaging, at a Worx dealer or on our
website at www.worx.com.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
This attachment is intended for edging around
walkways, driveways, flower beds, etc.
ASSEMBLY & OPERATION
Action
ASSEMBLY
Connecting
Remove the existing attachment and
connect the edger attachment. Slip
the attachment into the shaft of the
main unit and secure in place with the
locking knob.
OPERATION
Starting
Press the lock-off button first, then
press the switch trigger to start the
machine.
Adjusting the depth
Loosening the adjusting knob and
move the wheel arm up to increase
the depth or down to decrease the
depth according to your work needs.
After adjustment is complete, tighten
the adjusting knob securely.

OPERATION TIPS

1. The edger will edge among sidewalks,
driveways, flower-beds, curbs, and similar areas.
2. Cut at a steady pace. If the blade begins to bog
down, you are edging too fast; slow your pace.
Do not force the blade into ground.
3. Light contact of the blade against the sidewalk
edge, curb, and so on, is acceptable and will not
do damage to the edger.
4. Best performance is obtained when grass is
dry. Avoid edging in wet soil or wet grass areas
or the blade guard might clog and result in an
uneven edge. If the blade guard is clogged, stop
the machine, disconnect the power supply, or
remove the battery pack, then remove debris
from the blade guard.
Figure
See Fig. A
See Fig. B
See Fig.
C1, C2
EN