Installation Requirements - Whirlpool WPEC12MW Manual De Uso Y Cuidado

INSTALLATION REQUIREMENTS

Electrical Requirements—All Models
The electrical ratings for your evaporative air cooler are listed on
the model and serial number label. The model and serial number
label is located on the right-hand side of the Evaporative air
cooler cabinet.
Electrical Requirements
115 Volts (103.5 min.-126.5 max.)
■
0-12 amps
■
15-amp time-delay fuse or circuit-breaker
■
If there is a "Single Circuit Only" label on the unit, use on a
■
dedicated single-outlet circuit only. If a dedicated single-outlet
circuit is not available, then it is the customer's responsibility
to have a single-outlet circuit installed by a qualified
electrician.
If there is no "Single Circuit Only" label on the unit, the unit
■
may be used on any branch circuit of correct voltage and
adequate current protection rating.
Recommended Grounding Method
This evaporative air cooler must be grounded. This Evaporative
air cooler is equipped with a power supply cord having a
grounded 3-prong plug. To minimize possible shock hazard, the
cord must be plugged into a mating, grounded 3-prong outlet,
grounded in accordance with all local codes and ordinances. If a
matching outlet is not available, it is the customer's responsibility
to have a properly grounded 3-prong outlet installed by a
qualified electrician. It is also the customer's responsibility:
to contact a qualified electrician.
■
to assure that the electrical installation is adequate and in
■
conformance with National Electrical Code, ANSI/NFPA
70—latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269
Installation Instructions
Remove Packaging Materials:
Handle the evaporative air cooler gently while unpacking
■
the unit.
Remove the carton top and lift the evaporative air cooler from
■
the base pad.
Remove any tape and glue residue from surfaces before
■
turning on the evaporative air cooler. Rub a small amount of
liquid dish soap over the adhesive with your fingers. Wipe with
a damp cloth and dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your evaporative air
cooler.
Dispose of/recycle packaging materials in an appropriate way.
■
3