Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
In order to ensure that the motor remains comple-
tely watertight, we recommend checking the lip
seals once a quarter for signs of wear and tear,
and replacing them every 6 months.
When the seals are worn, liquid may first run into
the bearings, then reach the motor. If this happens,
the seals, the bearings and even the motor may have
to be replaced.
- Replacing the lip seals
Small
1
8 mm
2
Not indispensable
1) Tools needed
2) Remove the
bowl
See kit supplied
on delivery.
4) Unscrew the
5) Remove bolts
3 bolts
and washers
7) The stainless-
steel part and
deflector have
now been
removed.
3) Remove the
10) Replace the
bowl base seal.
bowl seal,
placing it on the
chamfer.
1
2
Only
Blixer
®
45 / Blixer
®
60
R 45/R 60
6) Put back the
bowl and pull up
13) Remove
1 mm thick
washer
5
4
3
8) Replace the
9) 5 to 3 in
inverse order
two lip seals.
Only
Blixer
®
45 / Blixer
®
60
R 45/R 60
11) Place 1 mm
12) Push down
thick washer
blade assy, stop
when hits motor
shaft
14) Put back
15) It's done !
the bowl, pou-
ring lip on left
hand side
• BOWL SEAL
The bowl seal, located bet-
ween the bowl and the bus-
hing, ensures that the bowl
remains watertight.
The bowl seal must be regular-
ly oiled, using food-grade sili-
Bowl seal
cone lubricant.
This part must be replaced each year, as the water-
tightness of the bowl depends on its degree of wear
and tear.
In order to make it easier for you to clean your
appliance, the bowl watertightness system is located
on the underside of the bowl.
As a result, a small area here may fill up with
foodstuff, though it will empty itself when the bowl is
released.
• LID SEAL
he lid is designed to be completely watertight within
the limits set out on page 12 (see examples of use).
In order to ensure that it remains that way, you may
have to change the seal occasionally, depending on
how regularly you use your machine.
If you do not use your machine regularly, we
recommend that you leave the lid open when it is not
in use jobs to preserve all these features.
• BLIXER SCRAPER ARM
The scraper arm is fitted with rubber wipers. These
are wearing parts, which therefore need to be repla-
ced from time to time in order to maintain optimum
efficiency.
The wipers are easy both to remove and to fit.
17
Publicidad
Tabla de contenido
