Setup; Before Startup; Installation Steps - Westinghouse NCCO1702 Manual De Instrucciones

For the first-time operation of the unit:
1. Please carefully read and retain the operation manual for future reference.
2. Remove all packaging materials, wipe all removable parts and grooves with a soft and dry cloth,
before assembling the parts.
3. Assemble the unit on a dry and level surface. Keep the unit at least 15cm (6") away from wall or
surrounding objects for normal operation.
4. Check power socket and all external power cords to meet previoulsy noted operational
requirements. Make sure the unit has been connected with power supply before operation.
5. The unit is installed with inductor to induce filters' location. If the filters have not been properly
installed, the unit won't operate.
6. When first switched on there warm air will be felt from the clean air out-put. This is perfectly
normal and is due to the manufacturing technique of the NCCO Reactor.

Installation Steps

1. Open Back Cover
Simultaneously press the
two buckles to open
back cover.
3. Install Filters
Install NCCO Reactor first into the 2 cavities of the
appliance, make sure the reactors click into place. Next
install the HEPA filters into the empty frames with the rib-
bon tab facing you (the screen pre-filter should already be
installed in the frame). The HEPA assembly then clips into
each cavity over the reactor with a solid click confirming
correct installation.
6
Before Start-up
2. Remove Filter Packaging Materials
Please remove NCCO Reactor(left) and
HEPA Filter(right) from packing materials
4. After installing all filters
Put the frames into unit and
close the back cover.
Notice
Please press filters with force
for proper installation.
Set-up