Publicidad
Idiomas disponibles
Idiomas disponibles
5.
When finished, switch the unit off, unplug the unit and re-
wrap the cord.
Electrical safety device
Circuit breaker: If the circuit breaker detects electrical overload
or short circuit conditions, the breaker will automatically shut off
the airmover. If this should occur, check the power cable carefully
for any damage and ensure it is plugged into a properly grounded
outlet. Press the Circuit Breaker Reset Switch (Fig. A) to
reestablish the electrical supply.
TRANSPORT AND STORAGE
Always use the handle to load or carry the unit.
For cord storage, wrap cord around top housing groove. Pull cord
snug and secure with plug clip (Fig. A).
Units may be stacked up to 3 high for transport and storage (Fig.
B). To stack, place one unit on top of the other in an upright
position. When transporting, secure the unit(s) carefully to prevent
sliding and damage to the unit and/or injury to vehicle occupants.
NOTICE! Keep unit dry. Do not expose the unit to rain or snow.
MAINTENANCE
WARNING: Unplug unit before performing any maintenance.
Before each use
Inspect the power cord. If cord is damaged, do not use. Always
grasp the plug (not the cord) to unplug.
As needed
Clean exterior of housing and grills.
WARNING: This product and other substances that may
become airborne from its use contain chemicals,
including lead, known to the State of California to cause
Fig. B: Stacking for Storage and Transport
Stack up to 3 high. Note airmover orientation when stacking
to optimize stability. Always tie down airmovers securely
when transporting.
124082D
cancer, birth defects, or other reproductive harm. For more
information, go to P65Warnings.ca.gov
SPECIFICATIONS
Model
Airflow
Static pressure (H
O)
2
Power/Amps (115v,
60 Hz)
Weight
Dimensions
(L × W × H)
Units per 15 amp
circuit
Sound level (avg.)
Control
Cord length
Construction
Safety
Specifications are subject to change without notice. Some values
may be approximate.
2
Sahara Pro X4 TurboDryer
(124315, 108028)
867 CFM | 1473 CMH
0.92 in. | 229.0 Pa
2.5 A (high)
2.2 A (medium)
1.9 A (low)
24.3 lbs. | 11.0 kg
17.4 × 15.0 × 17.3 in.
44.2 × 38.1 × 43.9 cm
Up to 4 (units set to high speed)
Up to 5 (units set to medium speed)
Up to 6 (units set to low speed)
63 dB (high)
54 dB (medium)
50 dB (low)
Variable speed rotary switch
16 ft. | 4.9 m
Injection molded polypropylene housing
components; injection molded ABS inlet
grill; steel wire outlet grill.
ETL listed to UL/ULc and CSA standards
Legend Brands, Inc.
Publicidad
