Sunex Tools 8054 Manual De Instrucciones página 2

aSSEMBLY INSTRUCTIONS
Step 1: Assembly Preparation
Remove all contents from box. Reference the
parts list to make sure you have all the parts.
Verify your tabletop or workbench
can support 150 lbs. (68 kg.).
Failure to follow this warning
CAUTION
could result in damage to
property or personal injury.
Cover table or workbench to
NOTE
prevent any damage to surface.
Step 2: Attaching Casters
Turn bottom tray (B) upside down. Align holes in
locking and non-locking casters with matching
holes in the bottom tray as shown in figure 2.a.
Attach washers and nuts from caster bolt kit and
hand tighten.
NOTE: Ensure that both locking casters are on
same end of the cart.
Step 3: Aligning the Legs
Make sure the drawer assembly lid is open. Place
two of the four legs face up on table as shown in
figure 3. Place drawer assembly (A) and bottom
tray (B) on legs as shown in figure 3 and align
with matching holes in legs.
8054 and 8054BK
2.
2.a
3.
2 rev.07/22/14