Speed Control - E-STAR DUAL STRIKER-11 Manual Del Usuario

TIP: It is much easier when you start to learn to fly the Drone, to ignore Turn Right / Turn Left. By using Up/Down, Forward/Backward, Bank Left/Bank Right, the Drone will
still be able to fly anywhere.
10. HOW TO DO A 360 FLIP:

11. SPEED CONTROL:

SPEED CONTROL: When you first turn on your Drone, it is set to 25% speed, you will hear ONE beep. When you press the SPEED BUTTON, you will hear TWO beeps and
the speed will be increased to 50%. Pressing the SPEED BUTTON again you will hear THREE beeps and the speed will increase to 100%. Pressing again will bring you back
to 25% speed and you will hear ONE beep. Always learn to fly at 25% speed, and then you can increase it as you get better at flying.
12. FLIGHT ADJUSTMENT SECTION:
When you lift your Drone into the air, and don't use any of the other direction levers, your Drone should simply hover in one spot without moving in any other direction. If
however it doesn't, you can follow the bellow instructions to TRIM your Drone back to a perfect hover.
When press the trim button, one sounds "Beep" means it enters the trim mode. At this time, the buttons of forward/backward/left-side fly/right-side fly turn into trim
functions of forward/backward/left-side fly/right -side fly. When finish trimming, press the trim button again or waiting for 2 seconds, with 2 "Beep" sounds, indicated quit
from trim mode.
When you press Forward Button the Drone will start to fly
Forward. When you press Backwards Button the Drone will start
to fly Backwards
1. Make sure the Drone is flying at least 2 meters above the floor and 2 meters bellow a ceiling.
2. Press the Flip button on the controller, The controller will make a "Beep" sound, then Press Forward/Backwards/Bank
Left/Bank Right Button once, and the Drone will flip in that direction.
3.You may need to push Up on the Up/Down Lever after the flip, if your battery is low on power in order to keep the
Drone high in the air after the Flip.
If your Drone banks to the Left, press the Trim Button into the trim
mode, keep pressing the bank Right Trim Button to the Right till
the Drone stops banking.
If your Drone banks to the Right, press the Trim Button into the
trim mode, keep pressing the bank Left Trim Button to the Left till
the Drone stops banking.