To Assemble The Chute Rotator; To Assemble The Chute Deflector - Husqvarna ST 124 Manual Del Usuario

3. Install the lower handle (D) into the 2 holes on each
side of the case.
4. Use the 3 M8x50 handle lock bolts (A), the 3 spacers
(B), the 3 handle knobs (C), and the 3 locking nuts
(D).
5. Install the upper handle with the control panel (E) on
the lower handle.
A
B
C
D

To assemble the chute deflector

1. Remove the rotator disk (B) and the 6 hexagon
flange bolts (D) from the case.
2. Attach the rotator disk (B) and the chute deflector (A)
onto the chute base using 3 limits blocks (C).
1272 - 003 - 09.08.2019
3. Use 6 hexagon flange bolts (D) and 6 locking nuts
(E) to lock the limits blocks (C).
D
C
B
A

To assemble the chute rotator

1. Assemble the front end of the chute rotator.
E
2. Install the plastic bushing (B) to the front end of the
chute rotator.
3. Attach the chute rotator with 1 flat spacer (A) and 1
hairpin (C).
4. Assemble rear end of the chute rotator.
A
D
B
C
E
C A B
7