Assembling The Antenna - RCA ATTIC/OUTDOOR COMPACT DESIGN Guía De Uso

Assembling the antenna

1. Attach the reflectors to the antenna boom.
Pieces used in this step:
(1) Antenna boom
A. Place the two reflector clamps on either side of the large hole on the antenna boom.
Line up the middle hole on each clamp
with the hole on the boom.
Place one of the M6x30 carriage bolts
through the clamps and boom as shown.
Screw a wing nut onto the other side of
the bolt (but don't tighten it all the way
yet).
B. Insert the reflectors into the clamps and tighten the clamps.
Turn the boom around. Place one of the
reflectors in the top part of the clamp as
shown.
Place one of the M6x30 carriage bolts
through the clamps and reflector as
shown. Screw a wing nut onto the other
side of the bolt (but don't tighten it all the
way yet).
Place the other reflector into the bottom
of the clamp. Place one of the M6x30
carriage bolts through the clamps and
reflector as shown. Screw a wing nut
onto the other side of the bolt.
Tighten all the wing nuts.
2
(2) Reflectors (2) Reflector clamps
Clamps
Bolt
(3) M6x30 carriage bolts
(3) M6 small wing nuts
Hole