Disposal; Trouble Shooting - Zipper Maschinen ZI-FKS315 Manual De Instrucciones

16.5

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
17

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
PROBLEM
Saw does not start．
Rip fence does not
move smoothly．
Rip fence does not
lock at rear．
Cutting binds or burns
work．
Wood edges away
from rip fence when
ripping．
Saw does not make
accurate 90ºor 45º
cuts．
Height/bevel
adjusting handwheel
is hard to turn．
Blade makes poor
cuts．
Blade does not lower
when turning height
/bevel adjusting
handwheel．
Motor labors in rip
cut．
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH
ZI-FKS315
Motor cord or wall cord is not plugged
in．
Circuit fuse is blown．
Circuit breaker is tripped．
Cord or switch is damaged．
Rip fence not mounted correctly．
Rails are dirty or sticky．
Clamp screw is out of adjustment．
Clamp screw is out of adjustment．
Blade is dull．
Working is fed too fast．
Rip fence is misaligned．
Spreader is out of alignment．
Wood is warped．
Ripping fence is misaligned．
Positive stops inside cabinet need
adjusting(Bevel Cuts)．
Miter gauge is misaligned(Miter Cuts) ．
Gears or post inside cabinet are clogged
with saw dust．
Blade is dull or dirty．
Blade is wrong type for cut being made．
Blade is mounted backwards．
Locking lever is not at full left position．
Blade not proper for rip out．
www.Zipper-Maschinen.at
CAUSE
N O T I C E
TROUBLE SHOOTING
SOLUTION
Plug in motor cord or wall cord．
Replace circuit fuse．
Reset circuit breaker．
Have the cord or switch replaced．
Remount the rip fence．
Clean and wax rails．
Adjust clamp screw．
Adjust clamp screw．
Replace or sharpen blade．
Slow the feed rate．
Align the rip fence．
Replace the wood．Always cut with
convex side to table surface．
Check and adjust the rip fence．
Adjust positive stops．
Adjust the miter gauge．
Clean the gears or screw post．
Clean, sharpen, or replace blade．
Replace with correct type．
Remount blade．
Move locking lever to left．
Change blade; rip blade typically has
fewer teeth．
40