Operation - Selecta FLOCUMATIC 4 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80385 REV 0 July/2019
¡ATENCIÓN! IMPORTANTE PARA SU SEGURIDAD
CAUTION!!! IMPORTANT FOR YOUR SAFETY
1
2 3
4
J
.P. SELECTA s.a.u.
To install the stirring bars, raise the anti-slip base and insert them into
the holes.
To obtain the required illumination, proceed as follows:
a. To adjust the height, loosen the lateral screws, slide the element to
the desired height, and tighten the screws again.
b. To change the lighting angle, loosen the lateral screws completely
until you can see that the pivot of the washer is free, move the light
to the desired angle, and tighten the screws again, checking that the
pivots fit back into their housing.
Place FLOCUMATIC LED mains suitable with the equipment con-
sumption.
Do not install the equipment in areas where inflammable liquids are
stored or in zones with special protection.
Do not use the equipment if it is not earthed.
Be sure that the voltage supply is the same than the one indicated
on the characteristics plate.
If you change the plug, bear in mind the following:

OPERATION

CONTROL PANEL:
1. Digital display indicating speed and time in minutes.
2. ESC key.
3. Button for reducing parameter value.
4. Button for increasing parameter value.
5. Enter (Start/Stop) button.
5
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
(It can be modified without notice)
Blue cable:
Brown cable:
Yellow/green cable:
Page: 10
Neutral
Phase
Earth
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62