Setting The Transmission Frequency; Setting The Frequency Manually; Selecting A Frequency From A Group; Scan Function - JTS MONACOR UF-10R/12 Manual De Instrucciones

UF-10R
has been called up, the first character
position is selected:
User Name
UF-10R
Char:1/10
Turn the knob PUSH / CONTROL to set the
desired character. Press the knob to go to the
next character position. After setting the name,
press the button SETUP to save the setting.
4) If it is difficult to read the display, call up the con-
trast setting via the menu item
Setup Contrast
Turn the knob PUSH / CONTROL to set the con-
trast. Then press the button SETUP to save the
setting.

6.2 Setting the transmission frequency

Before switching on the corresponding transmitter
(UF-10TB / 12 or UF-12TH / 12), set the receiver to
an interference-free transmission frequency. There
are various methods to do this:
1. The transmission frequency can be adjusted man-
ually between 624.000 MHz and 694.000 MHz
(chapter 6.2.1).
2. For operating several audio transmission sys-
tems at the same time (chapter 6.2.2), there are
12 groups with up to 60 channels in each group
( table on page 36, 37). In ideal conditions,
up to 40 channels from a group can be used for
audio transmission at the same time.
The scan function can be used to determine the
channels being used for transmission by other
systems (chapter 6.2.3). These channels will be
skipped during channel selection.
3. Preferred frequencies can also be stored in
your own six frequency groups (chapter 6.2.4),
e. g. when operating several audio transmission
systems in varying locations.

6.2.1 Setting the frequency manually

1) Call up the frequency setting via the menu item
Frequency
of the main menu.
Setup Frequency
634.375 MHz
G: 2 CH:11
Fig. 6
Contrast
5/7
Fig. 7
Fig. 8
2) Turn the knob PUSH / CONTROL to set the fre-
quency in steps of 1 MHz.
3) For fine adjustment in steps of 0.025 MHz, press
the knob so that the digits after the decimal point
are highlighted. Then turn the knob. If the fre-
quency is identical to the frequency of a channel
in the group, the group number and the channel
number will be indicated in the bottom line.
4) Press the button SETUP to store the frequency
selected.

6.2.2 Selecting a frequency from a group

.
The easiest way to operate several audio trans -
mission systems at the same time is to select the
frequencies for the systems from one of the
12 groups.
1) Call up the group and channel selection via the
menu item
menu.
Setup Group
G: 7 CH:22
650.575 MHz
2) Turn the knob PUSH / CONTROL to select the
group.
3) Press the knob once to highlight the channel
number. Then turn the knob to select the chan-
nel. The corresponding receiving frequency is
indicated in the bottom line.
4) Press the button SETUP to save the setting.

6.2.3 Scan function

Before a transmission channel is selected, the scan
function can be used to determine if other trans-
mission systems are transmitting on the channels
of the UF-10R / 12 at the same moment. The chan-
nels already used will be skipped during channel
selection.
1) Call up the selection menu for scanning via the
menu item
1. All Groups
2. Result List
3. Current Group
4. Return
2) It is possible to scan the channels of all groups
( table on page 36, 37) [this will take a few
minutes] or only the channels of one group (this
is faster).
Group/Channel
Scan
of the main menu.
of the main
Fig. 9
Fig. 10
15