User Servicing Instructions - Holmes HTF3110A Manual Del Propietário

F E AT U R E S - O P E R AT I O N S
C L E A N I N G / M A I N T E N A N C E
ASSEMBLY INSTRUCTIONS
Assembly Time: 5-10 minutes.
Tools Required: Phillips head screw driver.
NOTE: MAKE SURE YOU REMOVE ALL CONTENTS FROM
THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR
PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.
1. Gently tip Fan Housing upside down.
2. Assemble base halves around power cord by sliding
posts of one base half into slots of second base half.
Refer to Figure 2.
3. Use the locator tab on the bottom of the fan housing
to line up the holes on the bottom of the housing
with the holes of the assembled base.
4. Secure the Base Halves to the Fan Housing with the 5
Base Securing Screws provided.
5. Run the Power Cord through the cord minders and
cord channel located underneath the base. Refer to
Figure 3.
6. Turn fan upright prior to operation.
OPERATING INSTRUCTIONS
1. Set the fan on a dry level surface.
2. Plug cord into any standard 120V AC outlet.
3. To turn the fan on, press the desired Speed Button
(1-2-3) on the Control Panel.
4. To activate oscillation, press the Oscillation Button
( ) on the Control Panel. Press a second time to
stop oscillation.
5. To turn the fan off, press the Off Button (O).
CLEANING/MAINTENANCE INSTRUCTIONS
Follow these instructions to correctly and safely care for
your fan. Please remember:
REPLACEABLE FUSE
If your (5 Amp, 125 Volt) replaceable fuse blows, please
visit our website at www.holmesproducts.com for
information on how to order a new fuse. Follow the below
instructions to replace the fuse on the plug.

User Servicing Instructions

1. Unplug your fan. Grasp plug and remove from the
receptacle or other outlet device. Do not unplug by
pulling on cord.
2. Open fuse cover,
on the top of the
by using your thumb
a flathead screwdriver to
down towards the
prongs.
NOTE: Ensure that fuse
cover is completely open
before attempting to remove fuse.
3. Remove fuse carefully by using a small screwdriver
to pry the fuse out of the compartment by the metal
ends of the fuse. (see Figure 4)
4. Place plug on a solid, flat surface. Insert new 5 Amp,
125 Volt fuse into fuse compartment and use a small
screwdriver to secure the metal ends of the fuse into
the compartment.
CAUTION: Risk of fire. Replace fuse only with 5
Amp, 125 Volt fuse.
5. Slide fuse cover closed completely. If fuse cover is
difficult to close, make sure fuse is secured in place
completely by pressing down on metal ends of the fuse.
6. Risk of fire. Do not replace attachment plug. Contains
a safety device (fuse) that should not be removed.
Discard product if the attachment plug is damaged.
Figure 4
located
plug,
Fuse
or
Fuse cover
slide the cover
Metal ends