Safety Warnings - JANE SOFT POTTY Instrucciones

CAUTION IMPORTANT,
KEEP THIS INFORMATION FOR FUTURE CONSULTATION
Instructions for use:
-Read these instructions carefully before use and keep them for future reference.
-Clean the product before using for the first time.
-Make sure the potty is assembled securely before the child sits on it.
-When the child has finished and is standing up, the liquid in the bucket needs to be emptied into the toilet.
-Clean before and after each use.
-Your child's safety may be affected if you do not follow these instructions.
Assembly instructions that must ALWAYS be carried out by an adult
1. Check that the removable plastic bucket (Diagram 1) A is in the base of the potty. Make sure that both parts
are fitted together correctly.
2. The potty has a musical chip with a cistern sound (Diagram 2) that is activated by pressing the button.
When using it for the first time, make sure that batteries have been inserted. Follow the instructions for inserting
and changing the batteries. Uses 2 x AAA-LR03 batteries (not included).
3. Next, pull the toilet roll holder out and fit the roll of paper on, not included in this pack (Diagram 3).
4. Check that the non-slip pads are fitted on the base of the WC Baby, as shown in diagram 4.
CHANGING AND INSERTING THE BATTERIES:
The batteries should be inserted by an adult. To insert the batteries, follow the steps below and see the diagrams
on page 2, No. 5.
-The battery compartment is on the back at the top.
-Gently lift the rubber part of the seat up to show the closed cover of the battery compartment.
-Use a screwdriver to unscrew the 2 screws holding the cover closed.
-Insert the batteries or, as applicable, remove the old batteries and replace them with 2 x AAA-LR03 batteries.
-Fit the cover back in place and don't forget to put the screws back in to close it fully.
-Check the 2 batteries are in the right position.

SAFETY WARNINGS

-Do not leave this product close to a flame or sources of intense heat such as electric or gas heaters.
-This product is not a toy. We recommend it should be used under an adult's supervision.
1)Do not expose this product or the batteries to fire or high temperatures, they could explode.
2)Warning: Do not use batteries that display signs of leaks or cracks. To avoid leaks or bursting, never mix
batteries of different types, makes, new and old batteries or ones with different charges. Used batteries must
not be thrown on a fire.
3)Read and follow all the warnings and instructions supplied by the battery manufacturer.
4)Keep the batteries out of the reach of children.
5)Rechargeable batteries must only be recharged under the supervision of an adult.
6)Rechargeable batteries must be removed from the product before being recharged.
7)Non-rechargeable batteries must not be recharged.
8)Used batteries must be removed from the product.
9)The batteries must be inserted with the correct polarity.
10)The power supply terminals must not be short-circuited.
11)Do not short-circuit the power supply terminal.
Cleaning and maintenance:
-Take the batteries out before cleaning the product following the instructions above for changing the batteries.
-Use a damp cloth for cleaning the outside of the product.
-Clean the bucket with soap and water.
-Remove the batteries if the product is not going to be used for a prolonged period of time.
-Store in a dry place away from sources of light and heat.
4