tomado TGH6001S Instrucciones De Uso página 22

Surface burners applied do not require adjustment of primary air. A correct flame has distinct internal cones of blue and green colour.
A short, humming flame or long, yellow and smoking one, without clearly outlined cones, shows improper quality of gas in the
household piping or a damaged or soiled burner. In order to check a flame, heat a burner for around 10 minutes with a full
flame, and next turn the valve knob to the economical flame position. The flame should not go out or jump onto the nozzles.
* The rating label on the product indicates for which type of gas your appliance is suitable. Check with the service organisation
of Inventum if you want to adjust the appliance for different types of gas. Find the method in the manual of the conversion kit.
G25/25.3 mbar*
(kW)
1 0,95
2 1,70
3 2,90
Exchange of a burner nozzle
Unscrew the nozzle with a special socket spanner No 7 and replace with a new one according
to a type of gas (see gas table).
Caution! Adapting the appliance to a different type of gas than is indicated by the manufacturer of the hob on the rating label,
or purchasing a hob for a different type of gas than supplied to the house, is exclusively the responsibilty of the user and the fitter.
Caution! After adjustment is completed, place a label indicating the type of gas to which the hob is now adapted.
1 Simmer burner
2 Semi-rapid burner
3 Rapid burner
In hobs with a safety device, a knob with a surface burner safety valve is used, fig. Knobs should
be adjusted with the burner switched on and set to the economical flame position, using an
adjustment screwdriver of the size 2.5 mm.
EN - 22