Operation - Husky HD12120 Guía De Uso Y Cuidado

Operation

1
Preparing the inflator
Place the inflator on a flat surface, near the item that
□
will be inflated.
□ Insert the power cord (H or O) into an appropriate
power source (12 Volt DC or 120 Volt AC).
□ Connect the air hose (G) quick connect valve adaptor
to the item you are inflating, and push the valve lock
lever down to secure the connection.
Set the power selector switch (B) to the desired
□
position (12 Volt or 120 Volt). The digital pressure
gauge (C) will show the current pressure of the item
you are inflating.
2
Operating the inflator
CAUTION: Avoid over‐inflating. Never exceed the
recommended pressure, as items overinflated may
burst and cause serious injury.
Press the scroll buttons (J) to set the desired PSI
□
(between 3 and 120). When the digital pressure
gauge (C) is displaying the target PSI, the readout will
blink three times at the desired preset level, and then
change back to the current PSI level of the item you
are inflating.
Press the on button (K) to begin inflating the item.
□
The inflator will automatically stop when the item
reaches the preset PSI level.
□ Disconnect the power cord (H or O) from the power
source.
NOTE: The preset PSI level can be changed during
inflation using the scroll buttons. To stop the inflator
during inflation, press the off button. Disconnecting the
power cord will clear the preset PSI setting.
4