EN
5.1.2
CLEAN THE SPRAY TIP
1. Use a straight paper clip or cleaning tool (21) to clean the
spray tip (11).
2. Flush and clean the unwanted materials out of the spray
tip (11) with the garden hose (20).
3. Install the clean spray tip (11) to the spray wand (2).
6
TRANSPORTATION AND
STORAGE
Disconnect the power cord and watter supply hose before
transportation and storage.
6.1
MOVE THE MACHINE
•
Point the spray wand in a safe direction.
•
Only hold the machine with the handgrip.
6.2
STORE THE MACHINE
Make sure that the spray gun, the uberflex hose and the
pump are dry.
Make sure the machine is out of the reach of children.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
•
Disconnect the garden hose from machine.
•
Wind the power cord and the uberflex hose.
•
Clean housing and the plastic components with a moist
and soft cloth.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
If needed, call the customer service phone number
(enter number here) for servicing instructions.
•
Store the machine in a dry, isolated and frost-free area.
WARNING
WARNING
WARNING
NOTE
English
7
TROUBLESHOOTING
PROBLEM
The motor does
not start.
The machine does
not reach high
pressure.
12
POSSIBLE
SOLUTION
CAUSE
The power button
Set the power
is in the "OFF"
switch to the
(O) position.
"ON" ( | ) posi-
tion.
The power cord is
Connect the power
not plugged in.
cord to the power
supply.
Electrical outlet
Try another elec-
does not supply
trical outlet.
sufficient power.
The circuit breaker
Let it cool, and
is tripped.
start the machine
again.
The power switch
Pull the spray gun
is on, but you do
trigger.
not pull the spray
gun trigger.
The diameter of
Replace with a 1"
garden hose is too
(25 mm) or 5/8"
small.
(16 mm) garden
hose.
Water supply is re-
Check garden hose
stricted.
for kinks, leaks,
and blockage.
The water supply
Open the water
is not sufficient.
supply fully.
Spray tip has not
Install desired
be installed onto
spray tip to end of
the spray wand
wand.
properly.
The water intake
Remove filter and
filter is clogged.
rinse in warm wa-
ter.