Replace The Sanding Plate; Select The Sanding Plate; Operate The Machine; Maintenance - Powerworks CFG303 Manual Del Operador

EN
4. Roll off the sanding sheet from the dust box.
5. Push new the sanding sheet tightly against the
bottom side of the sanding plate.
7.4

REPLACE THE SANDING PLATE

1. Pull off the sanding sheet or the polishing
accessory.
2. Loosen the four screws fully and remove the
sanding plate.
3. Clean the top side of the new sanding plate. Apply a
thin layer of synthetic grease to the outer ring
hatched grey.
4. Attach the new sanding plate and tighten the four
screws again.
Replace a damaged sanding plate immediately.
7.5

SELECT THE SANDING PLATE

The machine can be equipped with sanding plate with
different hardness for different operation.
• Medium (black): used for all sanding work,
• Soft (grey, accessory): used for intermediate and
fine sanding, incl. on convex surfaces.
7.6

OPERATE THE MACHINE

Surface sanding
1. Start the machine.
2. Put it with the complete sanding surface on the
surface to be worked and move the machine with
moderate pressure over the workpiece.
The removal capacity and the sanding pattern are
mainly determined by the selection of the sanding
sheet, the preselected orbital stroke rate and the
applied pressure.
Use only initial sanding accessories.
Rough Sanding
1. Attach a sanding sheet with coarse grain.
2. Apply only light pressure to the machine so that it
runs at a higher stroke rate and high material
removal is achieved.
NOTE
English
Fine Sanding
1. Attach a sanding sheet with fine grain.
2. By lightly varying the application pressure or
changing the orbital stroke rate, the sanding plate
stroke rate can be reduced whereby the orbital
action is maintained.
Polishing
1. Select a low orbital stroke rate (level 1 – 4) when
polishing in order to avoid heating up the surface
excessively.
2. Apply the polish onto a somewhat smaller surface
than you intend to polish. Work the polishing agent
in with a suitable polishing tool applying it crosswise
or with circular motion and moderate pressure.
3. Clean the polishing accessories regularly to ensure
good polishing results. Wash out polishing
accessories with a mild detergent and warm water;
do not use paint thinner.
Do not allow the polishing agent to dry out on the
surface, otherwise the surface can become damaged.
Do not subject the surface to be polished to direct
sunlight.
8

MAINTENANCE

8.1

CLEAN THE MACHINE

The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
9

TECHNICAL DATA

Voltage
Speed
Orbits Per Minute
Orbit diameter
Sanding plate dimension
Weight (without battery)
Battery model
Charger model
8
NOTE
CAUTION
20 V
Single speed
-1
11,000 min
0.03 " (0.8 mm)
90*140 mm
0.75 lbs
BAP series
CAP sereis