Taking Your Blood Pressure Reading; Recalling Measurements In Memory - MABIS Healthcare 04-595-001 Manual De Instrucciones

Taking Your Blood Pressure Reading

Proceed only after reading the previous sections of this manual.
1. Position the monitor on a flat, stable surface with the digital
display panel in view. Insert the cuff tubing connector into the
left side of the monitor, Fig. 1.
2. Rest your elbow on a solid surface with your palm facing
upward. Elevate your arm so that the cuff is at the same level as
your heart, Fig. 2. Relax your left hand.
3. Press the POWER button to turn the unit on and select the
memory bank you want your reading to be stored in by pressing
the MEMORY button to alternate between, memory bank 1 or
2. Press the POWER button to confirm your selection.
4. The monitor will begin to guide you with voice prompts if the voice function is turned on.
This unit will run a self-test, Fig. 3, and show the last measured reading, Fig. 4, or if
there is no previous measurement, "0"
as shown in Fig. 5.
5. When the display appears as shown,
Fig. 6, the monitor is ready and will
begin to guide you with voice prompts
if the voice function is on. The cuff will
automatically begin to inflate.
6. The display will show the increasing pressure in the cuff. Along with the
measurement progress on the left side of the screen.
7. The cuff will automatically inflate to approximately 190 mmHg.
8. Once the cuff inflates to approximately 190 mmHg, the measurement will
begin.
9. The unit will begin to automatically delfate and the numbers appearing on
the display will decrease.
10. When all the air is deflated, the measurement is complete. The unit will display your
blood pressure (systolic and diastolic) measurements and pulse rate, Fig. 7.
With the voice function on (L1 or L2), the monitor will say the measurement with the
language you selected according to the classification standard of WHO (World Health
Organization).
Fig. 3
Fig. 4
– 14 –
11. Record you readings on a chart.
12. At this point, your measurements will be automatically saved in
memory.
13. To conserve the batteries, press the POWER button to turn the power
Fig. 1
off. Otherwise, the unit will automatically shut off after approximately 1
minute.
14. Disconnect the tubing from the monitor prior to storing.
NOTE: This monitor inflates the cuff to approximately 190 mmHg. If the system detects that
the cuff needs additional pressure, it will automatically reinflate to approximately 40mmHg
higher than the last systolic pressure reading.
Fig. 2
You can recall up to 120 total measurements in memory (60 per memory bank). These
measurements can be shared with your physician or trained healthcare professional.
1. Press and release the MEMORY button. The unit will display either
U1 or U2 depending upon the user bank selected. It will also show how
many measurements are stored within that bank, Fig. 1.
2. To select the appropriate user bank press the POWER button to switch
between U1 and U2.
Fig. 5
3. Once the desired user memory bank is selected, press the MEMORY
button again to scroll through the saved measurements. After you've
scrolled through all the readings, the unit will automatically turn off.
NOTE: Each memory bank can store up to 60 readings. When the number
of readings exceeds 60, the oldest data will be replaced with the new record.
To erase all stored measurements:
1. Press and release the MEMORY button. The unit will display either U1 or
U2 depending upon the user bank selected and how many
measurements are stored within that bank.
Fig. 6
2. Select the desired user bank by pressing and releasing the
MEMORY button.
3. Press and hold down the Memory button until two horizontal lines flash. This
indicates that all measurements within the selected memory bank have been erased.

Recalling Measurements in Memory

– 15 –
Fig. 7
Fig. 1
Fig. 2