Troubleshooting - Worx WX840L Manual De Instrucciones

TROUBLESHOOTING

Symptom
Tool does not operate properly:
green light flashing
green light on
red light flashing
red light on
Tool operates properly, but
fasteners do not drive fully
Tool operates properly, but
fasteners are driven too deep
Tool jams frequently
20V Cordless 18 gauge Nail/Staple Gun
Possible Causes
Tool is overheat
No nails
Jammed nails
Low battery
Depth of drive isn't deep
enough
Nail is too long for wood
hardness
Depth of drive is too deep
Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Possible Solution
Wait until the tool cools down
Replenish nails
Removing a jammed nail
Recharge battery
Adjust depth of drive
Use nail length that is appropriate for
wood
Adjust depth of drive
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
11
EN